Tile Grout

DESCRIPTION:

AT-TILE GROUT is a high performance cementitious polymer enriched and sand free grout which offers excellent color uniformity, durability with excellent waterproofing properties. It is easy-to-use.

USES:

• AT-TILE GROUT is designed for use on ceramic tile, glass tile and stone applications, for both residential and commercial purpose
• It can be used for both interior and exterior on floors and walls
• Ideal for re-grouting applications

ADVANTAGES:

• For internal & external use
• Suitable for floor & wall, anything from 2 – 20 mm joints
• Suitable for under-tile heating (heat screeds) and for plywood overlay floors
• High quality finish
• Free of primary efflorescence
• Crack resistant
• Quick drying – sets in 2 hours (approx)

COVERAGE:

• When being used on the wall with a tile 150 x 150 x 5.5 mm using a 2 mm grout joint:
  • The coverage would be around 4.8 sqm per 1 kg

• When being used on the floor with a tile 300 x 300 x 9 mm using a 3 mm grout joint:
  • The coverage would be around 3.8 sqm per 1kg

INSTRUCTION FOR USE:

• APPLICATION
  • CLEAN THE JOINTS
    • Clean the grout lines and scrap any protruding grout and clean again. Don’t scrap too hard or you may damage the tile
  • MIX THE GROUT
    • Pour the grout in water and mix with a margin trowel until all the powder is dissolved smoothly. Approximately 350 ml water is required for 1 kg of AT-TILE GROUT. Roll the bucket frequently during mixing. Scrap the bottom of the bucket to make sure all the grout is mixed properly to obtain desired consistency.
  • LOAD THE GROUT FLOAT
    • Tilt the bucket towards you. Drag some grout “up the slope” then scoop it onto the float.
  • SPREAD THE GROUT
    • Spread the grout diagonally across the tile to force it deep into the joints and ensure that it does not come out of the tile joints.
  • SQUEZE OFF THE EXCESS
    • Remove bulk of the grout by wiping in a serpentine motion. This helps evenly distribute the grout and prevents the grout float edge from digging into grout lines.
  • SPONGE OFF THE SURFACE
    • Sweep a damp (not wet) sponge diagonally across the tile. Rinse your sponge often and repeat until you are left with a thin haze.
  • TOOL THE LINES
    • Depress the sponge with your index finger and smooth out high or uneven grout lines. Don’t push too hard. Your goal is to have joints with same shape and depth.
  • RUB OUT THE HAZE
    • After the grout film has dried, polish away the haze with a cotton towel or for better results use a microfiber towel.
  • CLEANING
    • Clean all re-usable tools in water immediately after use.

TECHNICAL DATA:

PACKAGING & STORAGE:

• AT-TILE GROUT is available in the following pack:
  • 500 g plastic coated paper box with additional LDPE bag inside
• Shelf life is 12 months when stored in correct conditions
• Protect from frost. Store in clean, dry conditions between 5°C and 30°C.

HEALTH & SAFETY:

• Protect hands with rubber gloves and eyes with goggles.
• Accidental splashes to the skin or eyes must be rinsed immediately with clean water.
• Store in well-labeled containers.