• +91 33 4001 73 13
  • response@adochemicals.com

Plast 260(I) M

DESCRIPTION:

AT-PLAST 260 (I) M is a highly effective water-reducing agent and super plasticiser for promoting accelerated hardening and free flowing concrete. Does not contain any added Chloride.

STANDARDS:

It complies with IS: 9103 and ASTM C 494/C 494M -99a Type E

USES:

  • AT-PLAST 260 (I) M is useful where excellent where high early strength combined with powerful water reduction is required with excellent flow-ability.
  • AT-PLAST 260 (I) M is used for the following types of concrete:
    • Ready mix concrete
    • Pumped and construction concrete
    • Slip form concrete
    • Concrete at mild to cold temperatures

ADVANTAGES:

  • Combination of hardening accelerator and high range water reducer
  • Excellent high early strength
  • Good workability and slump life
  • Compatible with air entraining agents
  • Non-toxic, does not promote corrosion
  • Ultimate strength is not affected
  • Also suitable at very low atmospheric temperature

TECHNICAL DATA:

APPEARANCE Brown liquid
TYPE Polymer type dispersion
SPECIFIC GRAVITY (@ 25ºC) 1.10±0.02
SOLID CONTENT (%) 38.0±2.0
pH VALUE (@ 25ºC) 7.0±1.0
CHLORIDE CONTENT (%) < 0.02

CONSISTENCY:

  • AT-PLAST 260 (I) M is formulated from carefully selected raw materials and is manufactured under controlled condition to produce consistent product.

HANDLING:

  • AT-PLAST 260 (I) M is formulated from chemicals, which present no fire or health hazards.

RATE OF ADDITION:

  • With small dosage the increment of slump is more. The dosage depends on the cement content and the W/C ratio.

DOSAGE:

  • Minimum Dosage should not be less than 0.25% by weight of cement
  • For soft plastic concrete 0.6 – 0.85 by weight of cement
  • For flowing self-compacting concrete (S.C.C) 0.8 – 1.2% by weight of cement
  • Actual dosage depends on site trial

ADDITION : AT-PLAST 260 (I) M is added to the gauging water or added into the concrete mixer. To obtain the optimum result of high water reduction we recommend thorough mixing at a minimal wet mixing time of 60 seconds. Addition of remaining gauging water to be fine-tuned as per concrete consistency, the same may only be started after 2/3 minutes of the wet mixing time to avoid surplus water in the concrete.

PACKAGING & STORAGE:

    • AT-PLAST 260 (I) M is available in 250 kg HDPE container
    • Shelf life is 12 months in original & sealed packing
    • Storage condition should be free from frost and protect from direct sunlight
    • Keep packing in cool, dry place away from heat, cold and moisture
    • Stir material well before use

Plast260(I)M

HEALTH & SAFETY:

  • Protect hands with rubber gloves and eyes with goggles.
  • Accidental splashes to the skin or eyes must be rinsed immediately with clean water.
  • Store in well-labeled containers.