• +91 33 4001 73 13
  • response@adochemicals.com

Laker(AC)

DESCRIPTION:

AT-LAKER (AC) is water based acrylic polymer coating. AT-LAKER (AC) is clear lacquer that gives glossy finish to the surface and is also scratch resistant. It gives good abrasion resistance and increased durability of costly stone. It provides a transparent coating on the concrete surface. . AT-LAKER (AC) is highly recommended for designer tiles, tiles, decorative stones, paver tiles, etc.

RECOMMENDED SURFACES:

  • Paver blocks
  • Interlocking pavers
  • Natural stones
  • Slate
  • Terra-cotta tile
  • Concrete floors
  • Not intended for use on glazed, polished, or non-absorbing surfaces, wooden floors and decks, showers, countertops, or near pool areas

ADVANTAGES:

  • Two-in-one formula leaves a light sheen and gives protection against stains
  • Water-based formula
  • Easy to use
  • Suitable for interior use
  • Environment friendly

USP:

  • Resistant to oil and grease stains
  • UV resistant bond, non yellowing
  • Fast drying and long lasting
  • Retards efflorescence
  • Excellent adhesion
  • Water repellent
  • Easy to apply
  • Re-coatable

DIRECTION FOR USAGE:

  • Always test in a small inconspicuous area to determine appropriate application method, achievement of desired results, and to ensure good adhesion.
  • Ensure that the work area is well-ventilated during application and until surface is dry.
  • Keep children and pets out of the area until foot traffic resumes.
  • Avoid applying in direct sunlight.
  • Surface must be thoroughly clean, dry and free of any sealers or coatings before application.
  • Application on a dirty or dusty surface will affect adhesion and appearance.
  • High Gloss Finishing Sealer should not be applied to a wet or moist surface.
  • Avoid applying onto surfaces not intended for treatment.

COVERAGE & DRY TIME:

  • Coverage varies based on porosity and texture of surface. Test advisable before application.
    • 1 kg will cover 50 sq.ft to 60 sq.ft. for single coat, depending on the nature of surface
    • Normally 2 coats recommended
  • Dry Time:
    • Touch Dry : 10-15 minutes

APPLICATION METHOD:

  • Liberally apply 2 even coats with a natural bristle brush, roller, or paint pad applicator. Do not apply product with a sprayer or sponge. Failure to apply a sufficient amount of sealer to the surface may result in an undesirable finish or degradation of the coating. More coats may be applied if desired.
  • For extreme conditions additional coats may be required depending on the nature of surface.
  • Allow 30–45 minutes between coats or until surface is dry to the touch
  • Surface traffic may begin 12 hours after final application; keep installation dry for a minimum of 12 hours; full cure is achieved in 24–48 hours
  • Keep surface clean and dry as finished surfaces may become slippery when wet

TECHNICAL DATA SHEET:

FORM Colourless Liquid
SPECIFIC GRAVITY AT 25ºC 1.01
pH VALUE 8

PACKAGING & STORAGE:

  • AT-LAKER (AC) is available in the following pack:
    • 20 kg HDPE container
  • Shelf life is 36 months when stored in correct conditions. Shelf life is shortened once container is opened.
  • Protect from frost. Store in clean, dry conditions between 5°C and 30°C.

HEALTH & SAFETY:

  • Protect hands with rubber gloves and eyes with goggles.
  • Accidental splashes to the skin or eyes must be rinsed immediately with clean water.
  • Store in well-labeled containers.
  • If required get medical attention.