• +91 33 4001 73 13
  • response@adochemicals.com

Insta Leak

DESCRIPTION:

AT-INSTA LEAK PLUG is an extra quick setting waterproofing compound to seal water infiltrations.

USES:

  • AT-INSTA LEAK PLUG is used to seal infiltrations and plugging wet cracks in concrete and masonry surfaces.

ADVANTAGES:

  • AT-INSTA LEAK PLUG is an effective compound for severe water infiltration in concrete, rock and masonry. Key benefits are:
    • Easily hardens under continuous wet conditions
    • Acts as an effective crack sealer in concrete and masonry surfaces
    • Seals immediately on contact with water
    • Can be used to fix nozzles for grouting

INSTRUCTION FOR USE:

  • Remove all loosely adhering particles.
  • Then add AT-INSTA LEAK PLUG with cement at recommended dosage and hold it against the source of leakage.
  • Remove hand/finger slowly from the source after 15-20 seconds.
  • Please note that permanent repairs should be carried out by using ADO’s other product range.

RECOMMENDED DOSAGE & USAGE GUIDELINES:

  • Mix 1 part of AT-INSTA PLUG with 2 parts of Cement (preferably OPC) by volume.
  • The diluted material to be applied by brush and should be consumed on the same day.

TECHNICAL DATA:

TYPE Inorganic
COLOUR Red
SPECIFIC GRAVITY 1.21±0.02 kg/ltr (approx)
SETTING TIME 1 to 3 minutes

PACKAGING & STORAGE:

  • AT-INSTA LEAK PLUG is available in the following pack:
    • 1 kg / 5 kg / 25 kg / 250 kg PACK
  • Storage condition above 10ºC
  • Shelf life is 12 months in sealed containers as provided
  • Protect AT-INSTA LEAK PLUG from direct sunlight
  • Keep containers sealed and away from heat and cold in a well ventilated area
  • Stir material well before use

HEALTH & SAFETY:

  • Protect hands with rubber gloves and eyes with goggles.
  • Accidental splashes to the skin or eyes must be rinsed immediately with clean water.
  • Store in well-labeled containers.