• +91 33 4001 73 13
  • response@adochemicals.com

Bitucote

DESCRIPTION:

AT-BITUCOTE is an emulsified thixotropic acrylic modified bitumen protective coating. The coating dries to form a black flexible protective film. The finished film forms a tough barrier to vapor transmission.

 

STANDARD:

AT-BITUCOTE conforms to ASTM D 1227, Type III, Class 1

USES:

  • AT-BITUCOTE is recommended for :
    • Ground slabs and walls
    • Toilets and planter box
    • Roof decks
    • Landscape deck
    • Concrete, masonry, asbestos and metal substrate

ADVANTAGES:

  • AT – BITUCOTE provides the following beneficial advantages:
    • Fast drying (dries in less than 2 hours)
    • Non-toxic
    • Retains elongation
    • Resists the attack of salts like chlorides and sulphates that are present in the soil
    • Easy to apply
    • Cold applied
    • Adheres to concrete, metal, wood, cork, etc.
    • Asbestos free, odorless and can be applied in closed or confined spaces.
    • Water-based and therefore is non-toxic
    • Non- flammable
    • Versatile

SURFACE PREPARATION:

  • All surfaces must be free of grease, oil and dust. Very smooth surfaces should be roughened for better adhesion.
  • Surface faults such as blisters, holes and cracks should be cleaned, and then repaired with flexible filler.
  • Small hair-line cracks can be painted with AT-BITUCOTE brush in, allow it to dry, then repeat until filled or at least sealed.
  • Rusty metal should be cleaned by blasting or other means for suitable standard then primed with a Rust Converter. Other metals should be suitably primed or treated.

TECHNICAL DATA:

SOLID CONTENT 62% (approx)
ELONGATION AT BREAK (ASTM D 412) 65%
CRACK BRIDGING > 1 mm
ADHESION TO CONCRETE > 0.4 N/mm²

PRIMING:

Priming is recommended for weak and porous surfaces, to fill up pinholes and shrinkage cracks. Dilute AT-BITUCOTE with 40% LOCAL THINNER and spread evenly over the substrate.

APPLICATION:

  • Apply AT-BITUCOTE directly from can.
  • Apply in 2 coats at coverage of 0.50kg/m² per coat. Allow the 1st coat to dry before applying the 2nd coat. Leave to dry for 24 hours before further construction activities.
  • A fabric reinforcing matt can be laid in between the 2 coats if required. The reinforcing matt will increase the tensile strength of the waterproofing film and for bridging cracks and weak areas.

GENERAL APPLICATION:

  • Depends on the scale of work being carried out, but for small areas a paintbrush is ideal, keeping coat thickness 1mm approximately on gutters, valleys, walls, down-pipes, filling cracks, protective coating and spot applications.
  • On roofs or medium flat areas a squeegee or large sweeping brush can be used for speed efficiency.

NOTE: Brushes and squeegees should be cleaned immediately after use with LOCAL THINNER. Use solvent or thinner for cured film.

PACKAGING & STORAGE:

  • AT-BITUCOTE is available in the following pack:
    • 200 ltr HDPE container
  • Shelf life is 12 months in sealed containers as provided
  • Keep containers sealed and away from heat and cold in a well ventilated area
  • Stir material well before use

HEALTH & SAFETY:

  • Protect hands with rubber gloves and eyes with goggles.
  • Accidental splashes to the skin or eyes must be rinsed immediately with clean water.
  • Store in well-labeled containers.